Bronco_69
Bronco Guru
CB member MP will be doing an efi conversion in the near future and wanted a harness to fit his needs.
1. removed the 10 pin connectors to eliminate the problems with them.
2. removed all smog except the egr.
3. installed 12v tap for the 3g alternator.
4. removed all the ac wiring etc.
5. there will be about 3.5' of wire for him to locate the computer in the cab
6. there will be 3 relays. one for the fuel pump, one for the eec, and one for the O2 sensors / 12v+ in crank and run.
7. there will be 5 connections. 2 grounds, 1 battery, 1 crank, and one to the OEM 3 prong connection.
I will post more pics in a few days as I can only work on it on my days off.
some mock up pics.
1. removed the 10 pin connectors to eliminate the problems with them.
2. removed all smog except the egr.
3. installed 12v tap for the 3g alternator.
4. removed all the ac wiring etc.
5. there will be about 3.5' of wire for him to locate the computer in the cab
6. there will be 3 relays. one for the fuel pump, one for the eec, and one for the O2 sensors / 12v+ in crank and run.
7. there will be 5 connections. 2 grounds, 1 battery, 1 crank, and one to the OEM 3 prong connection.
I will post more pics in a few days as I can only work on it on my days off.
some mock up pics.