KennyB
Full Member
KennyB’s Ghetto Fabulous Bronco Rotisserie
OK, I don’t have ANY Friends to Share a Rotisserie with, So, I didn’t wanna get too Financialy tied up with one.
So, Harbor Freight posts Coupons in the Car/Truck Rags for Engine stands… $40….
2 Engine Stands
4 Pneumatic wheels
10’ Unistrut (Or anything else that will fit in the lower bar)
Some Scrap metal to run to the Body Mount Holes
4 Bolts
4 -18” ½” Pipe Nipples
2-1/2” pipe Couplers
2 -48” 1.5” Angle Iron, To widen the Stance, it was "Tippy, so I cut and “Boxed Around” the lower Bars.
I threaded two pipe Nipples to each coupler, and Slotted the ends. Slid down the door openings a few inches, then took my pipe Wrenches, and twisted them enough to lock into place.
I use Motor cycle Tie downs to hold the Bronco still. No, I can turn it all the way over, but I can put it almost 90*
If No one wants this after I pull the body off of it, I spent so little on it, I can roll it to the curb for the Scrap metal guys…
OK, I don’t have ANY Friends to Share a Rotisserie with, So, I didn’t wanna get too Financialy tied up with one.
So, Harbor Freight posts Coupons in the Car/Truck Rags for Engine stands… $40….
2 Engine Stands
4 Pneumatic wheels
10’ Unistrut (Or anything else that will fit in the lower bar)
Some Scrap metal to run to the Body Mount Holes
4 Bolts
4 -18” ½” Pipe Nipples
2-1/2” pipe Couplers
2 -48” 1.5” Angle Iron, To widen the Stance, it was "Tippy, so I cut and “Boxed Around” the lower Bars.
I threaded two pipe Nipples to each coupler, and Slotted the ends. Slid down the door openings a few inches, then took my pipe Wrenches, and twisted them enough to lock into place.
I use Motor cycle Tie downs to hold the Bronco still. No, I can turn it all the way over, but I can put it almost 90*
If No one wants this after I pull the body off of it, I spent so little on it, I can roll it to the curb for the Scrap metal guys…
Attachments
-
Rotissery 1.jpg91.3 KB · Views: 307
-
Rotissery 2.jpg172.7 KB · Views: 272
-
Rotissery 3.jpg77.7 KB · Views: 257
-
Rotissery 3a.jpg75.6 KB · Views: 247
-
Rotissery 4.jpg158.3 KB · Views: 259
-
Rotissery 5.jpg109.3 KB · Views: 241
-
Rotissery 6.jpg108.3 KB · Views: 234
-
Rotissery 7.jpg103.6 KB · Views: 236
-
Rotissery 8.jpg105.2 KB · Views: 213
-
Rotissery 9.jpg110.2 KB · Views: 202
-
Rotissery 10.jpg106.3 KB · Views: 201
-
Rotissery 11.jpg86.9 KB · Views: 198