Hey,
After a little searching, it appears using a liberal amount of RTV to form a gasket is a preferred method. Is there any downside to this method long term?
Are there even pre-manufactured gaskets that can be used between a T-18 and an adapter, and between the adapter and the D-20?
I could go either way.
Thanks
Jeff
After a little searching, it appears using a liberal amount of RTV to form a gasket is a preferred method. Is there any downside to this method long term?
Are there even pre-manufactured gaskets that can be used between a T-18 and an adapter, and between the adapter and the D-20?
I could go either way.
Thanks
Jeff