Anyone have a clue as to the pick up tube ? My ? is if I do an actual tube, it should come in then turn 90* down right, what about if I did that , but then extended and bent the bottom another 90* and extended to the back angle of the tank, then drilled holes along the bottom so it could pick up fuel at extreme angles and low on fuel like this ____
l
l
l
l
l
-----------------------Holes on this side.
I am thinking doing this and then welding a bung outside for an AN- fitting and SS braided line. Asked before what about a need for return lines? Are they necessary? Can a vent be done in a different way or to a relocated canister in back? Sorry the program will not post the above rendering like I want think a square 2. Can I assume the mounting pads are to space the top from seat bolts or the like?