View Single Post
Old 10/17/17, 01:43 PM   #50
Gravel Maker
Sponsor/Vendor
Bronco Guru
 
Gravel Maker's Avatar
 
Quick with a Laser!

Sacramento
Joined: Sep 06
Posts: 2,328
bknbronco-

As long as you are running the 'big-bearing' axles then all should work just fine. Ours are for sure 1/2" holes, I'm not a spot currently where I can go measure the pattern, but it is the same as the stock big bearing pattern. From there out, should work with the stock drums, or the common disc upgrades.

Dan Fredrickson 916.600.1945
www.ruffstuffspecialties.com
Your Fab Parts Specialist
The New Industry Standard!
Gravel Maker is offline   Reply With Quote
 
Page generated in 0.24889 seconds with 59 queries