View Single Post
Old 07/17/17, 12:47 PM   #7
Rustytruck
Contributor
Bronco Guru
 
Rustytruck's Avatar
 
honest the bolder ran under me

El Monte CA
Joined: Feb 02
Posts: 6,453
Pull the u-joint. Then pull out the cap at the end of the yolk, then use a bar down the center and push out the splined end from the yolk. Assuming you have access to a press and maybe a bearing splitter for support on the press. You will likely have to tack weld the old cap in place or make a new end cap. Make sure you mark the yolk and the shaft so you can put them back together. Either that or chain both ends of the driveshaft and use a port a power to pull them apart.

1974, stock 302, C4, BFG KM2 33x12.5x15, 8in rim, detroit rear, trutrac front 4.11 gearing, Warflairs,2.5" lift, chevy disc conversion, Hydraboost, owned since Christmas Eve 1977
Rustytruck is offline   Reply With Quote
 
Page generated in 0.31728 seconds with 53 queries