farmerjohn
Jr. Member
- Joined
- Aug 28, 2011
- Messages
- 124
Hello Again, I bought an incomplete '77 project, w no doors installed and went to work on it. Before welding in my floor pans , i measured my door openings and found them wider at the top.....like by an inch on the drivers side and 3/4"on the passenger side. I have the front fenders and grill removed , top off ,doors off,dash out, sitting on new body bushings and 2"body lift. Any sugestions on how to square up the openings? I know the Bronco was in a wreck and has a different front clip welded on.... My first thoughts were to cut loose the front clip, pull the front door posts in to spec, brace them, then reattach the front clip. My second thought was to ask you guys. Whatcha think? Oh and thanks for your time!