> i am stuck trying to remove the inner clutch ring, i am working
> on my 73 bronco with a dana 44 axle, thanks alot guys
You're referring to the hub lock assembly?
This F100/F250 diagram from fordification.com website seems to
be same as the Bronco factory hub lock.
Take off the cover&knob assembly[1A050+1A029]. Remove the
inner snap ring[378392-S(QQ-81)] from the hub housing,
that allows removal of the actuator gizmos[1A051+1A053].
Remove the outer snap ring[371834-S(QQ-40)] from the end of
the axle shaft[3219-R.H./3220-L.H.]. Normally the clutch parts
[1A028+1A052] will pop right off due to the spring pressure.
If not, use a pick with a curved end or maybe a couple
screwdrivers to lever them out. The spring[1A054] should be
easy to remove, and you'll need a pick or screwdriver again to
get the spring plate[1A055] out. And that's pretty much all there
is to the hub lock assembly!