tonytheplumber
Jr. Member
So I got my trans back from the rebuilder today and realized that the hole in the end of the stator is supposed to house an input shaft. I don't know if the trans from this project truck ever even had an input shaft, but I know it doesn't have one at the current time. I don't think I would have misplaced it, but if it was in the old torque converter when I trashed it and somehow didn't catch that, it's long gone. So, due to past experiences with ordering the wrong parts I'd like to know if one of you gentlemen would happen to know what input shaft I need? As in, what application is the correct one. Do I need to just do a spline count?? Are they all the same?? Are there different lengths? I learned my lesson on the flex plate and starter debacle I just went through. I don't want to be ordering the wrong part. AGAIN
Thanks in advance!
Thanks in advance!