- Joined
- Dec 26, 2006
- Messages
- 2,424
I have a vintage part also. Not stock on a Bronco but it is a Ford part.
Mark
Front cover part for a 427 SOHC engine??
I have a vintage part also. Not stock on a Bronco but it is a Ford part.
Mark
Here's my odd ball part, Todd Z and maybe Nick M need to keep quite
Your pic didn’t load.
I've got a super odd vintage part, not Bronco related but there are 2-3 folks here that might know what it's from, anybody up for a vintage challenge.
Here's my odd ball part, Todd Z and maybe Nick M need to keep quite
Is that the same Low that raced Datsuns off road back in the mid 70's?
More than just a t-case cover. It's a very special case cover.
You want a vintage catalog to go along with that part? Been holding on to it since the mid-'80's I think. Saving it for you...
I probably threw it out in the last purge though. Would figure.%)
Paul
Is that the same Low that raced Datsuns off road back in the mid 70's?
Yes, and he came back last year to race one of his old Nissans in NORRA. Still a darn good racer. It didn't have one of the axles that used this cover under it though.
Todd Z.
ooooh ooooh I know
it's a spring on a wood table
Is that a spring and valve from a proportioning valve?
Oil pump pressure relief?