First time replacing a floorpan. I bought the TBP 1 piece drivers side replacement and I have a fitment question.
I have most of the old one cut out. The outside edge / left side of the new pan has about a 1" lip that runs the full length of the pan.
I'm trying to figure out if this lip needs to overlap the small rail on the upper part of the rocker and I cut out a section for the crossmember or if I remove the lip all the way to the crossmember.
Sorry for the piss poor description.
Thank you!
I have most of the old one cut out. The outside edge / left side of the new pan has about a 1" lip that runs the full length of the pan.
I'm trying to figure out if this lip needs to overlap the small rail on the upper part of the rocker and I cut out a section for the crossmember or if I remove the lip all the way to the crossmember.
Sorry for the piss poor description.
Thank you!