bronko69er
EB Addict
Jeeze Dan, looks like you spend more time spending money than wheeling . Will it ever end?
Jeeze Dan, looks like you spend more time spending money than wheeling . Will it ever end?
Do you have any room to fit the bracket on the tube and weld it on the inside of the bracket instead of the outside of the bracket? How much tube do you have to work with on the drivers side?Because of the short driver's side tube, i'm likely going to be welding onto the cast center section for the link mount on that side.
Do you have any room to fit the bracket on the tube and weld it on the inside of the bracket instead of the outside of the bracket? How much tube do you have to work with on the drivers side?
How far forward would you have to push the axle to clear the drag link?
A triangulated 4 link front is very difficult to set up unless you use full hydro steering. Is that in your plan?
Good to see you're taking your time to think it out.
If you do a 4 link, is the main issue the steering linkage? My steering will be full hydro, and as i watch and read this thread i am seriously leaning to taking the long arms off and install this 4 link. It seems to be the way to go. I was thinking the lower arm to connect to the frame, similar to the long radius arms, and then the top link to attach in the center underneath the trans/ tcase.
Do you have your axle brackets yet Dan? I want to come down and look at your build as you get ready for your link / arm set up.