• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Pressure plate differences

gick70

Sr. Member
Joined
Jan 30, 2011
Messages
544
So I put a new clutch in luk,my other clutch from autozone,not a luk. I noticed that on the autozone diagram fingers came more to a triangle,where the throw out bearing rest,the luk more concave,so now I have more free play at the top of my pedal than I did before.Is there anyway to remedy this,I was thinking a stronger clutch spring,let me know!
 

Readhead

Full Member
Joined
Feb 7, 2018
Messages
155
Can you adjust the linkage at the fork that goes into the bell housing? Should take two half inch wrenches
 

Readhead

Full Member
Joined
Feb 7, 2018
Messages
155
Part 3915
 

Attachments

  • 45BE6E7A-4363-4530-BEA7-46357153A8D8.jpg
    45BE6E7A-4363-4530-BEA7-46357153A8D8.jpg
    83.2 KB · Views: 28
OP
OP
gick70

gick70

Sr. Member
Joined
Jan 30, 2011
Messages
544
No,it's adjusted right,it just has now all that free play!
 

Readhead

Full Member
Joined
Feb 7, 2018
Messages
155
I’m a truck mechanic they need two inches of free play on the broncos if your in high gear and have the RPM up a little you should still have at least a half inch of free play otherwise you will smoke your throw out bearing
 
Top