• Be EXTREMELY cautious if someone offers to buy your Bronco for more than your asking price and sight unseen. ESPECIALLY if the buyer is overseas. It's probably a scam.

    Discuss it more here:
    http://classicbroncos.com/forums/showthread.php?p=514932
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

GA ford trucks and parts 1969-79

Status
Not open for further replies.

jjjjjgrant

Jr. Member
Joined
Jan 16, 2012
Messages
106
Loc.
Grifin
parting out a couple trucks:
**1969 F100 LWB rolling frame with running 390, and C6 automatic. at least I'm pretty sure its 390, could be 360 its an FE engine. $500.00 I have to remove the cab and bed for one of my other projects. I have other trucks with disc brakes, power steering etc that will fit this frame.

**parting out several 1973-1979 trucks, (don't have any good beds currently) body parts, cabs 150.00 to 350.00, fenders 35.00 to 75.00 each, doors 50.00 to 150.00 each, hoods 50.00 to 150.00 each, grill shells 50.00 to 150.00, inner fenders, radiator supports, factory seats, most need recovered 35.00 to 75.00. steering columns 2wd 75.00 - 4x4 125.00 , disc brake parts 100.00 , power steering boxes 100.00 for 2wd 250.00 for 4x4, alot of misc parts, glass etc. . on body parts the lower price usually reflects parts that needs work, the higher price will reflect parts in good condition, likely needing minor work.

4X4 specific parts: front axle, dana 44, high pinion, disc brakes, coil spring suspension Good cond. $400.00 axle only, stock springs $50.00, 3-4" lift springs $75.00, 9" rear ends complete, $350.00 have one that is 3.50 track lock, have another that is 4.10 track lock, 31 spline axles. (2)NP435 4 speed married to NP205 transfer case $500.00. dana 70 dual rear wheel axle with 16.5 wheels 300.00

Engines: 95 351W roller cam engine complete w/ efi was running good when pulled with only 90K $650.00, C6 for small block $250.00 prob needs rebuild, 302 with NP435 granny 4 speed, can hear run $500.00, 390 with C6, can hear run, trans condition unknown $500.00, 1994 460, ran excellent with 200k on it, i'm about to pull out of truck only because rusted out freeze plugs $600.00 351 m, 400, 429, 460 4 speed bell housing with clutch fork and block plate. 150.00

Frames/project trucks: 1979 short bed 2wd rolling frame, no body, disc brakes, 9" rear and power steering box $350.00,
1978 f100 2wd long bed rolling frame with cab, fenders, doors, hood but all have rust, running 302 with granny 4 speed, disc brakes, 9" rear, power brakes, power steering $750.00
1979 F100 LWB with decent cab only, no windshield or back glass, locked up 6cyl. with C4 trans, disc brakes, power steering, dana 44 rear $350.00
1974 F150 short bed, with decent cab, been robbing parts off it, so not much left but good frame, disc brakes and frame. $200.00
1978 4x4 lwb frame with junk bed on it, rear springs. about all other parts stripped off it. $200.00
1979 4x4 SWB bare frame, all parts been stripped off it, i do have cab for it. 250.00

still have the 78 crew cab 4x4, LWB,cummins project: commercial truck frame, engine 6BT 12V"P" pump, Eaton 5 speed, 2001 F350 axles, divorced NP205, cab has roof rust on passenger side, rolling chassis, alot left to do and figure out, mechanical, electrical, fabrication and welding. All the hard parts are there. $5000.00 FIRM, not interested in anything less.

1979 F350 crewcab XLT 2WD, cab and chassis, dual rear wheel, 460, auto, will run, but thats about all I know. dana 70 rear end, minor drip rail rust on passenger side. tilt wheel, no bed, frame was stretched for flat bed, ramp or roll back, has large saddle fuel tank, its a project, needs work to be nice, drivable. $4,500.00

1978 F250 4x4 single cab, 460 auto, dana 44 front, 60 rear. has been sitting for a while, had duals on rear and flatbed, but its gone. will run, but thats about all i know. cab is fairly solid, but a bit of the rough/ugly side. $1800.00

trades always considered, but no motorcycles, boats or rice burner fast and furious wannabees. Im into early mustangs, early bronco, jeeps or other interesting older 4x4's and of course old ford trucks, anything else you just have to take a shot and see, you never know. Shop equipment, metal working tools/equipment, two post lift.

call or text: 404-732-6550
 
Status
Not open for further replies.
Top