• Be EXTREMELY cautious if someone offers to buy your Bronco for more than your asking price and sight unseen. ESPECIALLY if the buyer is overseas. It's probably a scam.

    Discuss it more here:
    http://classicbroncos.com/forums/showthread.php?p=514932
  • The Classifieds forum is a place to buy and sell, not an open forum for people to give their opinions on Bronco values. Unless the seller specifically asks for help on pricing, please don't critique quality or asking price. If you're not interested then move on.

    Thanks!
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

CA dana 60 axles, KP front & FF rear, true track, 4340 shafts

Status
Not open for further replies.

-8

Sr. Member
Joined
Jan 9, 2013
Messages
451
Loc.
Lakeside
Dana 60 rear full floater, narrowed, Detroit truetrack, 3.55:1 ring and pinion gears, Caddillac El Dorado brake calipers, disc brakes, unused rotors available with two sets of hubs for dana 60 and Sterling/14-bolt. I have an additional center-section/pumpkin available. (Trade for Millermatic 252/Forney 270).


I also have a '78/'79 Dana 60 Kinpin with 35-spline 4340 shafts, 3.55:1 ring and pinion gears and it is set up for dual triangulated 4-link using James Duff lower coil spring mounts. There is no differential carrier. I have ~$4,000. into this front end. I would like to get a 350amp Miller mig welder for it.

(I will get pictures later)

IMG_5039_zpsmpwvwxku.jpg
[/URL][/IMG]


IMG_5039_zpsmpwvwxku.jpg
[/URL][/IMG]
 
Status
Not open for further replies.
Top