Over the weekend I had to run the flashers for about 20 minutes. When I turned the flashers off,the right turn indicator on the dash continued to flash, along with all exterior turn indicators with the exception of front left. With the flasher switch on all work properly. I pulled the fuse for em flash/brake lights and the rear turns would both flash in either left or right position while the fronts worked correctly. This is a two year old build with new centech harness, new ididit column, and new turn signal buckets. All have worked perfectly the past two years. I’m pretty confident in my grounding on these circuits, and my initial guess is probably with the switch in the column with voltage getting to the flasher in either position but the issue with turn signal circuit at the same time has me puzzled. I haven’t dug into it yet, thought I would throw it out to the group before I start chasing gremlins..