661buster1963
Full Member
- Joined
- Feb 18, 2009
- Messages
- 287
I have my Dana 20 ready to put back together and notice some small pits in the seal area of the shift rails near where the shifter linkage hooks in. I thought about just putting it together as is but did hit the surface with some oil and 400 wet/dry paper but Is there a cheap and easy process? Thought about thorough cleaning and rubbing some wax on the rails. If the answer is buy new ones or weld the surface and put in a lathe and tHen turn it down I will live with what I have can’t Leak that much. Thanks in advance