bob_lafrentz
Sr. Member
1969 Ford Bronco (over $30k in this rig)
I have it listed on Ebay right now, http://http://www.ebay.com/itm/112341105444?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
If you want any pics or anything, just holler. Thanks for looking.
- New ignition switch, lock cylinders, headlight switch, dimmer switch, turn signal switch
- Radiator cleaned and rebuilt, new radiator hoses, heater hoses, and radiator brackets
- Door hinges rebuilt
- New Centech body harness and ignition switch harness
- New NV4500 (5-speed manual) and Atlas II transfercase from Advance Adapters
- Centerforce II clutch
- New high angle drive shafts (front and rear)
- IDIDIT tilt steering column and Grant steering wheel
- Flaming River steering column joints
- New BC Broncos power steering kit
- Rebuilt D44 front axles with new seals, bearings, Warn hub locks, braided brake lines, F-150 tie rod conversion, new bumpstops, new bushings, new trackbar, heavy duty D44 axles, F-150 heavy duty knuckles/spindles, new ball joints, and new rotors/calipers/pads
- Rebuilt Ford 9” rear axles. New wheel cylinders/brake shoes/drums, braided steel brake lines, new axle seals/bearings and pinion seals/gaskets.
- BC Broncos power brake kit with new vacuum assist and master cylinder. Also, new brake lines and adjustable proportioning valve.
- 1993 Mustang GT 5.0 transplant. Bored .030” over. Ported and polished. Rebuilt by Dave Hiatte Machine Shop in Clovis, CA.
- New 3G high output alternator
- New plugs, wires, and rebuilt distributor
- Wild Horses titanium shorty headers
- New accelerator cable, speedometer cable, and VSS sensor (Wild Horses)
- New O2 sensors, thermostat, and water pump
- New engine wiring harness
- Rebuilt heater box with all new gaskets, new high volume blower motor/cage, and heater core
- 3.5” suspension lift and 2” body lift from BC Broncos. Heavy duty shackles with greasble bolts, heavy duty front shock mounts, heavy duty u-bolt kit, track bar riser, new nitrogen filled shocks, all new bushings and body mounts, and CAGE long arms.
- Heavy duty custom built rock sliders (.25” full wrap)
- Custom rear bumper with swingout spare tire carrier and high-lift jack mount.
- Back seat (currently not installed, but as simple as a few bolts)
- Tuffy lockable metal center console with radio
- Bikini top
- Too many other new installed to list
- Boxes of extra parts….
I have it listed on Ebay right now, http://http://www.ebay.com/itm/112341105444?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
If you want any pics or anything, just holler. Thanks for looking.