Mechanical fuel pump to carb routing ideas

I'll start by saying the line coming up from my fuel pump has more twists and bends than I care to count. From the fuel pump the hard line makes its way up near the distributor cap where it connects to the fuel filter via a rubber line with hose clamps. From there the rubber line runs across the motor to the side of my Edelbrock carb.

I was looking at a few options from Edelbrock and I came up with this for the fuel filter and hard line running out of the carb. The price is reasonable.

http://www.summitracing.com/parts/EDL-8134

The line that runs from the pump to the filter is a little more than I want to spend if there are better options out there.

http://www.summitracing.com/parts/EDL-81243/

Any other options out there that look good and don't get in the way of anything else? Pictures would be great if you have any available.

I ran stainless steel braided (from Summit). I have an electric pump on the pass. side (my carb inlet is on the pass. side) , so I took it from the carb to the firewall, then down. But you might be able to do something similar.