Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!

If you have problems registering or can't log into your account, please contact Admin.

Members

B RON CO

Contributor

Bronco Guru From Statesville, NC

Joined: Jun 29, 2016

Last seen: Today at 5:58 AM

Latest activity Postings Images Gallery Albums Garage items About

- B RON CO replied to the thread 302 sounds loud at idle.
  
  Hi, the idle speed and the type of fan, among other things mentioned, can make an engine sound loud. Good luck
  
  Yesterday at 6:02 AM
- B RON CO replied to the thread Replaced your clutch and flywheel?.
  
  Hi, put a floor jack with a block of wood under the oil pan because the motor mounts are not enough to hold up the engine. Good luck
  
  Sep 8, 2023
- B RON CO replied to the thread Ignition Issue.
  
  Hi, the orange wire from the firewall looks out of place, especially with the crimp on connector. I would unhook it and see if the...
  
  Aug 29, 2023
- B RON CO replied to the thread Ignition Issue.
  
  Hi, if you have a tach disconnect it and see what happens. A defective tach could cause the trouble you are having. Good luck
  
  Aug 28, 2023
- B RON CO replied to the thread Brake and fuel line bending/flaring tips .
  
  Hi, most American car double flare tubes use a 45* flare. I hope yours came out the right way. Good luck
  
  Aug 11, 2023
- B RON CO replied to the thread Best way to remove oil pan 1966 170.
  
  Hi, you can change the pan if you lift the front of the motor. Be careful the fan does not hit the radiator. Good luck
  
  Aug 3, 2023
- B RON CO replied to the thread Coil replacement installation question.
  
  Hi, just so you know, the old coil requires a ballast resistor, or, in our early Fords, the resistor wire. Some ignitions require the...
  
  Jul 21, 2023
- B RON CO replied to the thread Brake line tightening down.
  
  Hi, I haven't been following the whole brake upgrade, but if you are using stainless line it could be hard to get the flares to seal...
  
  Jul 21, 2023
- B RON CO reacted to gnpenning's post in the thread Brake line tightening down with Like.
  
  You mentioned a couple areas for leaks. Be aware of the places that have copper washers. If the washer is to hard you will have...
  
  Jul 21, 2023
- B RON CO replied to the thread Kickdown.
  
  Hi, the Broncos never came with the bigger C 6 tranny. The pan on the C4 is rectangular. The pan on the C6 is like a stubby L. The kick...
  
  Jul 20, 2023
- B RON CO replied to the thread Clutch replacement and leaking rear main seal..
  
  Hi, I pulled the tranny once, the first time. Now the engine comes out. Anyway, I suggest you run a compression test first, and inspect...
  
  Jul 17, 2023
- B RON CO replied to the thread Hot hub after replacing bearings.
  
  Hi, everyone should know that when you tighten the outer lock nut that the whole assembly gets a little tighter. If the inner nut was...
  
  Jun 27, 2023
- B RON CO replied to the thread Right rear drum shoe question.
  
  Hi, I would get premium brake shoes from NAPA . Good luck
  
  Jun 26, 2023
Show older items
Loading…
Loading…
Loading…
Loading…
Loading…
Loading…

Members

Top