• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Recent content by Greenflan2

  1. G

    A Pillar Installation

    That is a good point and certainly could be part of the issue but I don't think it is the bulk of the problem. I was careful in my deconstruction to keep the old kick panel and A pillar as in tact as possible and the new parts appear to be close but upon careful inspection they are off enough...
  2. G

    A Pillar Installation

    I think you are correct in that they are all a little different. Some tweaking of new sheet metal parts should always be expected, but at a certain point it gets ridiculous. What's the point of buying a new part if you have to mangle it beyond recognition just to get it to fit properly? I...
  3. G

    A Pillar Installation

    Initially I purchased USA made kick panels and A pillars (1-piece) from a well known parts retailer. They were galvanized or galvaneal or something, looked like good quality parts but I couldn't get anything close, even with a lot of manipulation. So after much frustration I gave up and...
  4. G

    Advice needed on A Pillar Installation

    I’m in the process of replacing my passenger A pillar. Should I make sure the measurements from A pillar to B pillar are consistent at the top, middle and bottom and adjust/shim the door gap later or should my focus be on getting the door gap at the B pillar as perfect as possible before I weld...
  5. G

    United Pacific Sheet Metal

    Sorry to hijack this post but does anyone have any experience either way on the American made parts sold by bronco graveyard and others and how they compare quality wise to dynacorn or Dennis carpenter? I was planning to source door post, etc. from DC but they are indefinitely back ordered at...
  6. G

    Seat Platform Installation Question

    Thank you
  7. G

    What goes here?

    Thanks for the info!!
  8. G

    Seat Platform Installation Question

    Replacing my seat platform and the middle cross rail support (that goes right over the back of the transfer case) has some give/sag now that the old platform metal has been removed. I plan to permanently brace it up but want to make sure I get it at the right height so that front of the seat...
  9. G

    What goes here?

    On the driver side of the front cross rail supporting the front of the floor pan there are 4 threaded holes with (nuts welded inside). I just noticed them but no clue what they are for? I don’t see these on the passenger side. Sorry for the poor picture quality.
  10. G

    Rear Wheel Well Replacement

    I’m sure someone on here has done this on a lubr with the body on the frame and without using a lift, just curious how difficult it was. I can get the originals off just not sure how hard to will be to get a mig gun up under there to weld in the replacements since I’m not replacing the inner or...
  11. G

    Door post repair question

    Got it, thanks
  12. G

    Door post repair question

    Working on repairing a passenger side door post (rear) and not sure if the inside of the door post is supposed to be open like I found or if I should patch it closed? Don’t want to trap water or moisture if it’s supposed to be open? Thanks
  13. G

    A9L Tuning

    Got it, I will check into both. Thank you both!
  14. G

    A9L Tuning

    Is there anyone still remote tuning these? I think I need to start with having it flashed/reset. Any suggestions on who could help would be greatly appreciated.
  15. G

    351 9.5 deck with 11r heads

    Considering these heads as well (170’s) with a lightning intake. Any regrets from anyone running them? I think I’m going with an explorer CAM so probably don’t need the 190’s.
Top