Recent content by Rox Crusher

Looking great!

I hate the look of the body gap created by body lift, even a measly 1”. I ran a 4R70w without a body lift for quite some time and while there was slight clearance between t-case and crossbrace mentioned by Zoso, I found the clearance disappearing as the body mounts compressed over time...

Yes ineedy

I spent time hanging out with Jay at Supercell west and you are right he now sells direct. I've had his door panels, quarter panels, and headliner in my rig for several years. The fit and finish is great and they have proven to be very durable. I would encourage everyone to buy Jay's...

Yes, still available. I think Jay now sells through multiple bronco houses

Are you going to move the rear axle back to center it in the opening ? Mine has always had a lean to the left rear. Has nothing to do with driver weight I swear

This is what I did too. You will love these shocks !

Nice looking weld job, especially for fifty scoots

So your not using their adjustable drop bracket for the Terex Ames ?

Hey Fred great to see you starting your upgrade project. I’m starting to plan similar changes to mine and will watch your thread updates. Good luck with the project !

I installed a set on the front of mine when I went long arms last summer. Like them compared to the RS9000 I was running. Wanting to get a set for the rear but on back order.

I removed the heater box and turns out I had the connections to the resistor reversed so I corrected them. I also had the connections on the switch backwards but chose to leave those as is so the fan comes on in low mode first. All good now. The new fan seems to move more air and I don’t...

At the risk of complicating the discussion........ I replaced the original motor with the one from mid nineties Ford F-250. I reused the original fan cage.

any additional input guys ?

I think the motor itself is wired correctly as there are only two wires.......the ground wire and the orange power wire. Having said that, I may have connected the wires to the resistor backwards. I’m thinking that’s why the motor is running backwards but that’s just a guess on my part. The...