Recent content by Texas Edition

Thanks for the response Chuck. I decided to go ahead and remove the tank to see if I can find out exactly what is wrong. I've already purchased a replacement pump from you and have it in hand. As far as the removal of the tank you made it sound easier than what I have experienced so far, but I...

Thanks for the info! I wasn't sure if you could do that!

I bought an in the tank low pressure fuel pump from BC Bronco to replace an existing one already in the tank( whom I bought it from originally). I have a carb engine with electonic ignition. The engine was originally and EFI and I decided to go the carb route so there is no place for a...

I need to remove a BC aftermarket fuel tank (23gal) to install new elec. low pressure fuel pump. The tank was installed when the body was off so it looks like its going to be a pain.Any short cuts or proper procedures would be helpful. Do I need to cut the fill tube and the other rubber hoses...

Thanks for the response! I'll gather up what info and can and relay it !!

Just getting to the point of really test driving my 72 complete rebuild. I took it for a spin today and when I would let off the gas you could feel the bronco surging like a liquid sloshing back and forth in a container, and you could hear some noise but not sure where its coming from or how to...

Inboxed you, hope it's not to late!!

Toreador Red? I love my choice of Toreador Red and Dark Shadow Gray for the top! Added some subtle ghost flames on the hood and fenders. To each his own!!

I think this is Toreador Red. I just liked the color and chose it for mine!!I can look the colors up on my Invoices when I dig them out!!

Thanks Viperwolf for the schematics I think that will help. If I can't figure it out I will give them a call Dusty!! Thanks for all the info, I was pretty sure someone on here could help. TimP I installed a tilt column and used the the switch in column! Thx everyone!!

Does anyone have a schematic for the T3 harness? I've got it installed but have an issue and seemed to have misplaced mine. I've emailed WCB but still waiting on a reply! Any help is appreciated. I think it is not offered anymore because when you pull it up on WCB web site it says it's not...

Yes I did order it from US Shift. I'm using a Holly 600 cfm with electric choke. So I'm assuming I have the correct TPS??

Installed a 4R70W tranny and ordered controller and Throtle Position Sensor (TPS). When the TPS was installed the valve covers interferred. So ordered a spacer for the carb so it would clear! Now there is no clearance with filter on carb when you close the hood. It is a roller rocker set up, and...

My other project Here's my other project or maybe I should say my Wife's project or vehicle. It was the only vechile that her Dad bought new!! Bought it from her brothers and got it restored with a few changes!!