• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Recent content by tk1218

  1. tk1218

    Wiper Parking issue

    Factory wiper motor The wipers keep running, will not turn off Thanks
  2. tk1218

    Wiper Parking issue

    Trying to figure out why wipers will not park. New Painless harness / new wiper switch / old wiper motor With switch installed, testing wires that go into the motor With switch in the off position - red wire only has power With switch in the 1st position - white wire has power and red wire...
  3. tk1218

    Wiring gremlins / FiTech

    Sorry, the fitech relays are on the kick panel with the ecu connected to it
  4. tk1218

    Wiring gremlins / FiTech

    Can something shorting in the fitech potentially take out the other circuits? I had a bad starter once take out the entire system until I disconnected it from the solenoid
  5. tk1218

    Wiring gremlins / FiTech

    Don’t really see any reason or relation to the issue which usually means a ground issue Yes on the ignition wire in the harness. When it’s cooled of the battery and coil read 12.5 at start. When running it’s around 14. When it stalls battery is 12.5 and coil is 10. Some of the accessory...
  6. tk1218

    Wiring gremlins / FiTech

  7. tk1218

    Wiring gremlins / FiTech

    High pressure pump powered via supplied relays with the kit When it heats up and stalls t/s switch not working + hazards and Dakota freezes up. High pressure fuel pump and only 10.6 volts to the distributor Constants are verified as b+ when cold, have not verified after it stalls (was on the...
  8. tk1218

    Wiring gremlins / FiTech

    Yes, running a return line. It’s the fitech version that includes the reservoir and high pressure fuel pump
  9. tk1218

    Wiring gremlins / FiTech

    Edelbrock from Reilly auto parts, the low pressure 1. Thought about running the high pressure 1
  10. tk1218

    Wiring gremlins / FiTech

    Background 73 bronco 302, fitech with fuel pump reservoir, Dakota digital, classic auto air, Petronix replaced point and new painless 28 circuit harness. Issue Starts, runs and then stalls after about 10 minutes. It appears that the fitech fuel pump is not getting power after it gets warm...
  11. tk1218

    Fitech fuel injection issues

    Is your fitech still working good?
  12. tk1218

    AMP power step by toms

    Wondering if anyone has any thoughts on the amp powerstep The instruction don’t seem very detailed so wondering how difficult it is to install and how well it works Thanks
  13. tk1218

    ZF + TRex = Drive Line problems

    Yes, same bc bronco crossmember
  14. tk1218

    Pate swap meet tms

    I know that a bronco vendor comes to the Pate swap meet each year, but can’t remember which vendor Does anyone recall the vendor? Thanks
Top