Recent content by Unknown

Here ya go! Sorry for the flipper shot.

Yep, the Wheel Vintiques 62 Series Primered Wheels 62-585504.

I went that route with summit racing/wheel vintiques.

Hi Hank, hope you're doing well. Did you hold on to your trailer?

Free rides and a beer when you're in town!

Door post...

Couple of thoughts on this. On my old STC top I took a tread die and ran some threads for two nuts to fit the rods at the windshield. It added a little adjustment but also firmed up the door frames so they stayed put. It was a little more work to fully drop the frames when you go top down but...

I ended up going with Wheel Vintiques from Summit Racing. They are 15x8 with 33's. No plans to run caps but later model dog dish may fit. I have seen some steel wheels on EB's with the inside tabs for smaller caps but to me that tab style looks off and more suited for the 50's trucks...

Promo Bronco. I spoke to one of the organizers and verbally agreed to participate, Bronco needs a good road trip! I think they have 5-6 leads on rigs but they are being a little selective regarding color, built and condition. They're looking for blue, yellow and white in sort of a beachy...

As far as messing up your paint: Your top can be set on the Bronco without the corner post installed. Then remover your taillight lenses and buckets. The corner post can then be fished up into place and bolted up.

Just for reference, this is a 33" x 10.50 on a 15 X 8" wheel. I'm 2.5 suspention lift with 1" body lift.

1" body, 2.5 WH coils, 33 X 10.50's.

I'd like to be added if possible. Thanks, nice work!

Redward - did you use an ARP kit or? If kit, have the part number handy? Thanks

Sounds like a PCV, rings or other issue causing your crankcase to create pressure.