Search results

Hey guys, I think I know the answer to this already but I thought I would run it by you. I have noticed lately that my tach will read erratically when at idle sometimes. The needle will swing up and down about a 1000 rpm. I can hear the engine stutter a little while this is happening and then...

If any of you play video games on a PC you should try out Spintires Mudrunner. It's a ton of fun.8-) To keep this Bronco related, Here is my favorite truck in the game.;D

We had a great turnout today and I think everyone had a blast. It was good to see everyone and we had a few new faces too. just got home and will upload the few pictures I took soon. 8-) Here are a few.

I searched around but couldn't find the spec for the wet float level measurement for a Bronco 2100. Any ideas?

I just had an odd problem start on my 77. Sometimes I will smell oil burning out of the left side exhaust. I don't see smoke but can smell burning oil. It only does it sometimes, randomly. Also when I crank it after it sits for a few days it will blow a bunch of smoke out the left side exhaust...

I had a problem with my C4 while on a trail ride today. While climbing some very steep and tall hills at a big sand pit the tranny neutral-ed out. It only happened if I went up really slow and after about 5 seconds of climbing. I think it is because the pan is running out of fluid because of the...

My stock 77 302 has developed a slight skip when over 2000rpms. I pulled the distributor cap just to check things out and found the the reluctor roll pin was sheared in half. Not even sure how it was running. Anyway after I fixed the roll pin/reluctor the skip was still there. I noticed that it...

I replaced the window gaskets on my hard top after I repainted it and now they leak really bad. What sealer would be best to use? I assume it would need to be something that is non hardening?

Where can I get a steel 2 groove water pump pulley that is smaller than a stock Bronco 302 pulley?

Got rained on yesterday and my windshield hinge leaks really bad. It drains right on top of the glove box and onto my speaker.:cry: I think I may have put the seal under the hinge backwards? which way does the fat side go, front or back?

Anyone running this tire wheel combo? Pictures? I am wondering if this rim will be too wide?

I'm working on restoring a hard top and after I sandblasted the rain gutters I coated them with POR15. It has been about a week and I noticed yesterday that the seams between the top panel and the rain gutter is bubbling up in a few places. Has anyone else had this issue? Any suggestions on how...

What size Motorcraft came on a 77 302? I have several old 2100s and 2150s that I need to rebuild. I want to replace the Holley 2300 on my 77 because of hard start when hot and it floods out over bumps. It's a 350 cfm but I think the stock motorcraft should be smaller. Any ideas?

I found one locally. Have a great day.

Any one here going to the big swap meet/car show this weekend in Moultrie?

What's the best deal going on a locker for my 77 9 inch? It will be driven on the street a lot (but not a daily driver) so a locker with good street manners would be best. I don't want to spend the money on a selectable locker.

Anyone on here?

Does this belong to anyone on here?

I was watching some video of the OUA 2010 and ran across this sick green EB. Check it out, starts @ 1:58. (Just ignore all the heeps and stuff.) Does this belong to anyone on here?

We have been trying to get the front brakes re-built on the front of a 74 D44 and can't seem to find brake drums to fit it. The drums that came on it don't line up with the shoe/backing plate and the ones we ordered from Toms are the same way. They lack about 1/4" - 3/8" of going back far...