Search results

I have never used the Eastwood tool but have used a snap on one many times. The snap on one worked very well and very fast. I have also installed them using a hammer and dolly. Hammer and dolly work fine but it is a lot more work I worked in a body shop and typically we put adhesive between the...

I am getting ready to paint my bronco finally after 12 years. My plan is to paint the underside of the hood, doors and fenders, then install the parts and paint the exterior. How do most people handle painting the cowl/windshield frame area? There is no break at the cowl to 'tape off' so just...

The folks that have install ac vents on your dash, how did you get them to work w the defrost duct? I would like to install three vents in the center of my dash but it will interfere with the defrost duct. Thanks

Mine is somewhat bowed in the middle. It was like something inside hit the tailgate and bowed it out. It is not terrible but also has some rust damage at the bottom. Mine doesn’t fit too great to start with I am assuming it is because of the bow. Thanks

Are all the reproduction tailgates the same? Anyone offer a better fitting gate? Any free shipping offers? I am debating whether to spend the time to repair mine or just buy a replacement

Do you have any close up pictures are what was cut and welded? Very cool idea Thanks for sharing

I recently purchased proflo 4 Efi. I am looking at the extra capacity 23 gallon fuel tanks. I see Toms Wildhorses bronco graveyard and protofab all sell them. I would prefer the in tank pump. Any suggestion on one of the venders. Anything special to take into consideration before buying one? I...

thanks for the info

What size are the fitting needed for a 75 ps. gear box. One looks like it is 5/8-18, is the other is larger than 1/2" so is it 9/16-18? 5/8" would only thread into one of the holes, if the high pressure the larger of the 2. thanks

I have a family style rear cage only (behind front and rear seats). is there anyway to tie the rear portion behind rear seat to the frame? There is a cross member, under where the cage pad steps. I am not too excited about cutting out the crossmember or a portion of it. The channel under the...

3m 8115 works good. That was the go to in the shop a few years ago.

I have seen a few builds that folks are installing in dash speakers. Usually it is two if them one on either side of the dash. The ones I have seen there was a metal mesh over the speaker Saw a couple on Nicks Trix Anyone have experience with adding the speakers? What size works best? Thanks

My gap between the fender and front of the doors were great. The gap between the door and quarter were very wide I welded some round rod to the back edge of the door, and now it is almost perfect. Getting the gaps close is very frustrating for sure. It is still challenging to get everything...

Looking for a dash pad that would fit a 75. I am ok with cracks. Prefer something in VA, MD, or NC

they are power seats. I was planning on using the mustang sliders. I do not have any way to post photos. thank

I picked up a pair of 2016 mustang power seats. The mounting hole do not line up, and I would like to move them back a bit anyways. Any photos or ideas on how you are mounting or moving the seats? I guess I could just put a plate on the underside of the floor? thanks for any ideas or suggestions

yeah i don't have that option.

what is the secret to posting photos? i have them on my phone, but cannot figure out how to add them.

it is the one that came out of my bronco, but i cannot say if it was connected to the dash originally. it has been a while since i took it out.

I just put my e brake assembly in and the mounting hole does not line up with the threaded hole on the bottom of the dash. I have the L shaped bracket from the dash to the kick panel but is there another bracket from the bottom of the dash to the front mounting hole on the e brake assembly? My...