Search results

Looking for a set of un-reconditioned connecting rods 5.1550" length for a 289.

https://albuquerque.craigslist.org/cto/d/espanola-1970-ford-bronco/7590566030.html

Has anyone built a roller cam 289? I'm looking for a roller cam for my 289 with 9.3-1 compression, ported iron heads with bigger valves. Best would be a cam with under .500 lift as I still have the press in studs. I'll be using link bar roller lifters so that should open up more options than...

I've got most of the wires hooked up in and around the engine bay but am left wondering about this one. Looks like a ground and thinking the other end connects to the engine block. Does it ground on the starter solenoid screw?

I need the lower radiator brackets and bushings if anyone has some laying around.

I have the original throttle linkage that has this accelerator assembly. Is there any benefit to keeping it other than originality? Think i have most of the parts. Or replace it with a cable or a link rod?

Getting ready to install the engine, transmission and transfer case and wondering what goes to these threaded holes in the pictures with arrows?

I know the water temp sensor goes in one of these holes but what about the rest of them? Do I plug them?

Looking for a good used distributor either points or duraspark.

After rebuilding my distributor I cracked the distributor shaft trying to turn the gear to line up with the roll pin hole. The gear was very tight and trying to turn the shaft with an allen wrench the shaft cracked. I thought about welding this crack or should I just get a new distributor? There...

Think I'm having an axle issue I haven't been able to diagnose. I've been pushing my 68' with factory front/rear limited slip differentials back and forth under a carport at a slight angle. When there's any angle in the steering the Bronco becomes hard to push and feels like one of the axles is...

Getting ready to install the stock 3 speed manual and dana 20 transfer case in my 68. These have all the original seals/gaskets and have not been run in 30+ years. Any advice as to which seals/gaskets to replace as preventative maintenance would be appreciated.

looking for the single groove crank pulley

Been scratching my head wondering how this alternator bracket mounts and location. I'm guessing on one of the cylinder heads?

If anybody has a set of cast iron exhaust manifolds laying around I'd be interested.

Got my seats reupholstered and trying to figure out how the passenger seat mounts in the back. The seats were out when I got this Bronco so I have no experience mounting them. Looks like the later years had a latch. Is the 68 seat just mounted loose in the back on some rubber bumpers?

Rebuilding my front seats and am looking for couple of these bolts. If anyone has a lead I'd appreciate it. Cheers, Matteas [/url]PXL_20211203_222402874_2 by matteas trinity[/IMG]

Silly me threw out the old master cylinder and push rod. The new one came with 2 different push rods. Which one do I use?

Looking for a used steering wheel for my 68 Bronco. Let me know what you have.

early bronco hub by matteas trinity, on Flickr Need one of these spring retaining plates part# TA055 for my factory front locking hub. It goes between the hub and the spring. Can’t seem to find this part to order it online, let me know if you’ve got one.