1/8" speed nuts for Sport emblem?

[OX1]

Only one of my new fenders had the holes, and they don't line up
too well with the replacement emblems. 1/8" speed nuts work OK?

 

[bronkenn]

They work real good, just thread them on the studs to get the threads cut before you install them. If you get too aggressive you could break a stud.

 

[OX1]

They work real good, just thread them on the studs to get the threads cut before you install them. If you get too aggressive you could break a stud.

Appreciate the reply. I was more looking for the size confirmation of someone that has done it on that specific emblem. No one has them
local and it's about $16 shipped for 10 of them......

 

[bronkenn]

!/8th inch ones are the correct size. Try doing a search for early Camaro rear trunk emblem nuts. That is what I used.

 

[1strodeo]

I took my emblem to Ace hardware and got small pushnuts, worked very well. the ones from JBG are shit

 

[OX1]

Thanks all. My coworker, a GM guy (nobody's perfect),
but a big car nut found the 1/8th one's at Lowes, .67c for four.

Seem to work OK, will need to see if studs stick far enough
out, once installed on fender.

 

[trailerjack]

Well....how did they work?