Okay, the 3 speed and D20 are out, Motorcycle lift took the whole assembly in one shot, and the flywheel is at the machine shop; NP435/NP205 are staged up.
What do I need to do to use my existing '75 EB Driveshafts on my '79 NP205 Transfer case yokes ? Is there a hybrid U-joint?
Does it work ok with the CV joints in the driveshafts?
Any experience??
Also, it looks like a good time to replace the pan gasket and rear seal on the engine. Anyone care to comment on how easy or difficult that is done.
One more item, how long do I cut the NP435 shifter shaft for use with gear banger shifter.
What do I need to do to use my existing '75 EB Driveshafts on my '79 NP205 Transfer case yokes ? Is there a hybrid U-joint?
Does it work ok with the CV joints in the driveshafts?
Any experience??
Also, it looks like a good time to replace the pan gasket and rear seal on the engine. Anyone care to comment on how easy or difficult that is done.
One more item, how long do I cut the NP435 shifter shaft for use with gear banger shifter.