4.11s for a Dana 44 Question

[noreasteb]

I recently changed the gears in the nine inch to 4.11s and now am looking to have the Dana 44 done.
I am currently running the stock 3.50 gears in the front. From what I understand is that I need a "thick" cut gear set to retain my existing carrier.
Would this gear set work for my needs?
http://www.rockauto.com/catalog/moreinfo.php?pk=2989308&cc=1105580

 

[01JLH]

That should work and be fine for the front, as we don't normally run in 4 wheel drive all the time and broncos are not known for being all that quiet.

 

[noreasteb]

Ya, I am not concerned about gear noise for the front but just want to be sure the ring gear and pinion will work with my current carrier.

 

[cs_88]

Those don't look like the "thick" gears you need. The thick gears should have a T at the end of the model number.

 

[welndmn]

Everything on the description says it's the correct one

 

[cs_88]

These are the gears you want for your carrier.

http://www.usastandardgear.com/ProductDetails.aspx?ProdID=3294

 

[cs_88]

You're right, the description says that they are the thick gears but the model number doesn't match.
You might want to call them. Or check Amazon.

http://www.amazon.com/USA-Standard-Gear-D44-411T-Differential/dp/B0078U9FO2

 

[skerrybronco]

x2
should have a T at the end of the model number

bought my gear sets from these folks, very reasonable, ended up with richmond and motive gears.

http://stores.ebay.ca/Quick-Performance-Racing
maybe give them a call for the thick gears

 

[noreasteb]

Yup, you guys are correct. I called them and they are not the thick cut without the 'T'.
Thanks for the help.