- Joined
- Apr 26, 2015
- Messages
- 2,629
Selling my custom made door and rear panels for my bronco. I am going a different route. I have over $650 into these. They were for a 77, they should fit other years.
They started out as high end door and rear panels. I removed the cardboard (which shouldn't be in a bronco) and had custom fiberglass panels made by bronco hut. I then used the cardboard to make door templates for push pins (uses stock holes) and used cardboard in the rear for the same. The push pins could be cut off and screws could be used. They already have cutouts for 6.5" speakers in the rear. The rears were trimmed to match the high end panels and both doors and panels were glued on with foam by a professional upholstery shop.
The push pin idea was so that you couldn't see any screws, for a nice clean look. I will ship them with all templates. Does not come with the speakers.
Message or email me.
duffymahoney@hotmail.com
They started out as high end door and rear panels. I removed the cardboard (which shouldn't be in a bronco) and had custom fiberglass panels made by bronco hut. I then used the cardboard to make door templates for push pins (uses stock holes) and used cardboard in the rear for the same. The push pins could be cut off and screws could be used. They already have cutouts for 6.5" speakers in the rear. The rears were trimmed to match the high end panels and both doors and panels were glued on with foam by a professional upholstery shop.
The push pin idea was so that you couldn't see any screws, for a nice clean look. I will ship them with all templates. Does not come with the speakers.
Message or email me.
duffymahoney@hotmail.com