brewdude
Bronco Guru
OK I searched the message board and did not find out what I needed. I installed my new Edlebrock carb and manifold, I went to start it and there was a backfire through the carb. I already checked to see if I had any wires crossed. I did move the distributer but I set the number 1 piston at TDC and lined it up, but it seemed a little off like maybe it was off a tooth. I played with it a while but could not get it perfectly. Any ideas? I hope to get this running before it gets too hot, it is supose to be 105 today. Thanks in advance.