Tuff68
Full Member
It looks like the PO's have installed several front seats over the years and my new seat brackets don't line up with any of them.
I have 10 holes ( 3/8" to 1/2" ) that need to be welded up and ground down befort brushing in my liner and installing the new seat brackets.
What is the best way to close these up using my welder.
Do I cut out small pieces of .048" sheet and try to tack it them weld or can a bolt of the hole size be inserted flush with the top of the hole weld and gring off from the under side.
I tried to just weld in one of the holes but could not get it to take. The material in this area is in good shape.
Thanks for your information.
David
I have 10 holes ( 3/8" to 1/2" ) that need to be welded up and ground down befort brushing in my liner and installing the new seat brackets.
What is the best way to close these up using my welder.
Do I cut out small pieces of .048" sheet and try to tack it them weld or can a bolt of the hole size be inserted flush with the top of the hole weld and gring off from the under side.
I tried to just weld in one of the holes but could not get it to take. The material in this area is in good shape.
Thanks for your information.
David