What tools

[Boss Hugg]

hmmm wonder what your inferring;D

no inferring, just jacking... %):-X:-X;D

Not jacking..just inferring.. LOL

Skiddy likes to drop hints and tips and tanks here and there... and on the trail.

But what fun is offroading without its challenges? Like I leave mistakes in my reports to my boss, you have to leave bread crumbs to make things interesting. Complete surprises take too long, so by leaving a problem you expect, you get moving again must sooner. "Lets see how far we get with it this time." Something for the TV folks...errr...someone, anyway... to watch for suspense.

 

[broncoman805]

Toilet paper and a shovel are important items to have. ��

 

[Revelation]

I have a small under the hood tool box in place of a side vent. We are getting ready to drive to the Super Celebration and I wanted to stock the box with the best option of roadside equipment. I am going to put in tire plug kit, Flat head, phillips, crescent wrench, wire cutters, silicone. I need wrenches but I have limited room. What size and type would you pack and what else?

Map your route, and stick to it. Find members who live along the route and get contact information. If things go bad a Bronco Brother will be close by!

 

[jw0747]

Hell, where do you even find baling wire anymore? Everyone around here bales in large round bales.

coat hangers...

 

[sykanr0ng]

coat hangers...

The wire quality of those is terrible, they are no fit substitute for baling wire.

 

[Slowleak]

Rebar tie wire.
https://www.homedepot.com/p/Weyerhaeuser-400-ft-16-5-Gauge-Rebar-Tie-Wire-05337/202094311

 

[Slednut10]

Last year when I went to SC I trailered the Bronco. I noticed a vibration driving it to Duffs from the rear and it turned out to be rear drive shaft u-joint. Changed it out at the show. Some folks apparently found it to be interesting and crawled under to see what I was doing.

A 1/2 inch *12pt* combination wrench for those above mentioned u-joints

 

[rmk57]

Small flashlight could come in handy.

 

[Skiddy]

Not jacking..just inferring.. LOL

Skiddy likes to drop hints and tips and tanks here and there... and on the trail.

But what fun is offroading without its challenges? Like I leave mistakes in my reports to my boss, you have to leave bread crumbs to make things interesting. Complete surprises take too long, so by leaving a problem you expect, you get moving again must sooner. "Lets see how far we get with it this time." Something for the TV folks...errr...someone, anyway... to watch for suspense.

just wait and see what kind of tid bits I leave around this year

 

[jw0747]

The wire quality of those is terrible, they are no fit substitute for baling wire.

What exactly is baling wire?

 

[Skiddy]

What exactly is baling wire?

you know, the wire you hang up your exhaust with

 

[BRONCO26]

Test light is very important!

 

[Rustytruck]

Zip ties, lots of zip ties.

 

[Tugross302]

Maybe just tow a snap on truck behind you

 

[Master Chief]

I must live on the edge. No tools, only a destination. I don't even carry a spare anymore.

Besides, I have friends in low places ;D Tim, Randy, Ken, Scott, Art, Dave, and Hank to name a few.

 

[sprdv1]

What exactly is baling wire?

Whoops.. bailing wire lol

 

[sprdv1]

A 1/2 inch *12pt* combination wrench for those above mentioned u-joints

For sure...

 

[Teal68]

As far as wrenches.....
7/16, 1/2, 9/16, 5/8 and 3/4 are my recommendations. Crescent wrench does not work in tight places sometimes!

 

[Acknud]

What exactly is baling wire?

Kids!.......Used on farms up until the 1980's. Pretty similar to rebar tie wire.;D

 

[Acknud]

As far as wrenches.....
7/16, 1/2, 9/16, 5/8 and 3/4 are my recommendations. Crescent wrench does not work in tight places sometimes!

Helpful.... I wasn't sure of the most used sizes. I bought a small multipurpose tool kit.