Recent content by bronconv

Have you thought about getting an over the counter flexible fuel tank liner and doing it yourself? There seems to be a lot of them out there and they don't seem to be to expensive.

Thanks for that link, I hadn't seen that on their site. I hadn't look that deep yet. Looks like I can do either and I don't have to take it down to the bare metal. I haven't purchased anything yet, other then their sample pack. I like the smoother texture of their product and that I can roll...

I've started prepping the interior to apply a bed liner. I'm leaning towards Monstaliner. Right now I'm using a grinder with a wire wheel to scuff up the paint. Would I be better off using a sander of some type? Like a DA sander? If so what grit would you suggest? Also would it be better...

Thanks, that's a big help. My harness came with only a couple connectors I'm going to use, like for the headlights. For the tail lights I'm crimping in blade type connectors.

I have a 71 that I am in the middle of rewiring. If I recall I have a EZ Wire harness set-up. I bought the harness so long ago I can't exactly remember the brand. ;D, Although for this question that's not important. I am using the original tail light assemblies but I cut the Ford pigtail...

Removed the dash, cleaned out most of the old insulation and got a good look behind it. Then put the dash back on and started running the new harness to the switches. Today was the longest I've worked on it at one time in about ten years. It was a great day!

I saw that. It was light blue. I was afraid it was going to get caught in the crossfire. Justified is a great show! One of my favorites.

Cool, I just went out and wired it up. It'll be a while before I can test it, but you got me started. Thanks for the help! Roger

My harness is an EZ harness, so the wire colors don't match Ford's. They are marked high beam and low beam. So by looking at the diagram all the headlight power wires come from the dimmer switch. So how can I tell which Ford wire runs to the high beam. Is it the Red/black or Green?

Hey guys, Real quick question. I'm putting a new three pronged headlight connector on my new harness and I'm not sure which is high beam and low beam. It's been a few years since I removed the old harness. The ground I can tell from the old harness. So I guess the question is: Does the high...

Thanks for the input. I never seen the braided type I'll have to look it up. Roger

I'm installing a new wire harness, I've got it pre-routed and am about to start cutting and attaching. As I run the harness down the frame I was wondering what type of harness protection everyone is using to finish up the job. Thanks, Roger

Modified the glove box liner to fit the new fuse panel. Pre-routed the new wire harness to get an idea how it should all go!;D