Recent content by Firemanjay

My coil is mounted on the passenger inner fender and I’m running Ford racing 8.5 spark plug wires.

I been having the same issues. I changed spark plug wires, relocated my coil and changed, have a Rfi plate I purchased and still had troubles a low RPM. I spoke with Holley about 20 times and then someone suggested grounding the module to a head then continue to the next head and then to the...

Is the axle still for sale?

Good afternoon I was giving a set of front and back axels from a 2022 Gladiator Dana 44 with E-lockers. I was wondering if anyone had any information regarding this swap. I know i will need to remove the 4 link attachments in the rear and add rear hangers plus shock mounts. In the front it will...

My passenger door gap is 3/8 “ bigger than the driver door. I noticed the rocker panel is pulled away from the back by the spot welds. Any advice how to fix the door gap issue? Do I need to loosen the body mounts and try to squeeze the gap closed? Really confused

I am looking for 83-95 302 block and heads. Do you have any ?

motor Do you still have the motor and is it carb set up or fuel injected.

Thanks for all the responses. I’m running a normal oil pump not a high volume. I’m running valvoline 20/50 oil. When the motor died just cruising at 70 mph down the road I had 40 to 45 psi oil pressure. I am currently looking into the clearance on the distributor and camshaft. The article a...

I drain the oil everything looked good and everything was good and clean in the filter. I ran the oil pump in a bucket and it works like it should. I also opened the pump up and everything looks good. I will reassemble the motor next week and check clearances on the distributor and cam shaft...

Oil pump is a standard volume pump that is 2 Year’s old.

Thanks Norman for the repost.

I need some help. My roll pin on my distributor has sheared off for the second time in 2 years. I have a 351W pretty stock with a duraspark distributor. While driving down the road at 70 mph my engine died after tear down I was able to determine the pin had sheared again. The last time this...

I just installed a duraspark distributor in my rig. I rebuilt my edelbrock carb installed distributor set timing approx 10 degress set idil then went for a drive. Around 1600-2000 rpms when i accelerate my motor coughs and backfires. If i just drive real easy it doesn't cough. Not sure if its a...

Offer Sir what will you take for the unit, bottom dollar? Thanks jay

Do you still have the top for sale