Recent content by tom9961

Thanks for the info sykanr0ng, Any idea what this would cost all the modifications that I would have to make. Drive line, transfer case adaptor and etc.

I have a stock 72 and was wanting to upgrade to a automatic trans. Does anyone know what the total cast would be to upgrade to one of the overdrive transmission I read about on this forum.

Yea! I might be interested. How much does he want? Is it all original? Is That the factory paint job?

Got all the prep done on my 72 bronco and off to paint it went. When it got back from paint and I begin reassembling everything I found a Oops. The guy helping with the prep or I failed to notice that the locks were the two sided key type from a later model ford and didn't completely cover the...

Tires are just street tires. P235/75R15. Pressure 35lbs.

I have a 72 bronco with factory power steering. I have replaced all the ball joints seals and bearings. Added disc brakes front and rear with hydroboost. New coil springs and shocks. Stock with no lift. West Texas Offload rebuilt my steering box and upgraded to a 3 turn lick to lock. It has...

Ok. Can I have my post back please. Does anyone else have any ideas about the play in my steering box input shaft. I really need a fix.

Oh I forgot rebuilt Bronco as stock. No lift regular size tires. New ball joints, wheel bearings all around, lower steering shaft, steering column rebuild, shocks, front coil springs, rear leaf spring and c bushings, duel exhaust and new gas tanks main and aux.

Yes I do have a in/lb torque wrench. I printed the image you posted and will try to check this setting in the next few days. If it in the input shaft an torsion bar can I get a replacement for that.

Thank broncodriver99 The slack is in the input shaft. I am stupid about the torsion bar and what WTOR used to convert the box. My question is can the slack be adjusted out of the input shaft or what I can do to resolve this issue. It is scary to drive. I need to fix this!

I have a 72 Bronco that has factory powering steering. I had WTOR rebuild it and upgrade to a 3:1 turn to turn ratio. After all the other repairs new ball joint, lower steering shaft, wheel bearings and steering column rebuild I still have play in the input shaft of the steering box. I sent it...

Thanks for all the replies. I had my stock EB box rebuilt with a 3 turn upgrade but I still have play in the steering. It seems to be from the box at the input shaft. It get a little scary at highway speeds with the three turn ratio. I even sent it back to the WTOR and they rechecked it and...

Can anyone share the instruction for using a toyota power steering gear box. Like what year and what models will fit. And will the pitman arm from my factory box work with the toyota box.

Google Jacknuts. They helped me with attaching the rear hinge for the back window since i did not have the corner post. The conner post had the nuts wielded for the hinge bracket to bolt to.