Search results

I need some opinions and things to check. Out on the high way at 50-55mph the Engine and Transmission heats up. The engine temp climbs past 180 and to 190 then I get off the highway out of fear of a sudden major over heat. The transmission may be OK it runs about 180 the whole time. In town I...

Out at Hollister Hills this Sunday. Any one going?

Hi all, I am working on putting the Duraspark back in on my 351w. I pulled what I needed off a 302 only to find that the hex shaft that drives the oil pump is smaller from the 302 that what I have. Is this correct or is there something I am missing?

Hi All, How do most of the after market rear bumpers mount to the rear frame? Are they built like the front bumpers with extra material for bolts through the frame? I have been thinking about fabricating up a rear recovery point that is behind the stock rear bumper using 2" trailer hitch...

As goofy as this sounds ever since I installed my Trans Temp gage it appears that the stock gages (Oil, Temp, Fuel) in the cluster are all reading too low. Is it possible that a little extra load on the same circuit is depriving the voltage regulator of what it needs?

Yesterday the inevitable finally happened, I rolled for the first time. I got really lucky it was soft ground, relatively slow and only went onto the passenger side. My winch and recovery kit worked great glad it was where I could grab it on my way out. My 77 only suffered minor damage and...

Has anyone thought of or attempted to install the newer style windshield washer nozzles that have a fan type of spray? Could the angle of the windshield and hood be too sharp of an angle to get good coverage? I was wondering if they might wash mud off the windshield better than the stock 4...

Searched a bit and could not find any info on aluminum alloy rim durability. I'm looking to get new rims for my 77 and wanted feed back on aluminum alloy rims designed for going off road. (not bead locks) I like the look of the Mickey Thompson Sidebiter but don't know if it is steel or...