Search results

On a factory heater delete, assuming: - No holes in dash for controls. - No holes in firewall for hoses and mounts. - Most importantly, what did they do with the passenger fresh air? No holes? Trying to figure out my build, I have no holes in the dash, someone put holes in the firewall (very...

Well, got this build going a few months back, still have a few decisions on direction but here are the starting stats. u13fl738xxx Roadster-170cid, 6cyl, Michigan Truck, Aug 65 092 B U130 796 C 03 ?, Caribean Teal, 6 Cyl, Roadster, Front Buckets/Roadster, 3 Speed Manual, 4.11 Rear Gear 75...

Looking to confirm the difference between the 66 vs 67 inner door trim panel. The 66 has 2 holes on the top including corners, with 3 on the bottom including corners. The 67 has four holes on the top including coroners and 4 on the bottom including corners. Can anyone confirm?

Looking for 66 rear axle, large fill plug and forward facing shock mounts. I have 68 / later style for trade if that helps.

Need 5 stock rims, 66 restoration.

Need early style manual steering column / wheel for 66 restoration. One without the flasher located on the column 66 through 69?

Need 66 Front Bumper

Someone cut off the 66 shock rear shock mounts, looking for a set.

Just looking for some confirmation. Bought a recover kit including foam for a set of 66 front bronco seats. Thought my seats were original but kit appears to not fit. I by chance also recent picked up a set of seats from a 67 bronco. The seats are different and the covers appear to fit. I...

Looking for the lock plate for a 66 hard top. Hoping someone has one out there.

I am replacing my front parking lights and the pigtail ends on the main wiring loom are damaged, does anyone have a source for new parking light pigtails?

The fill plug on my Ford 9" is weeping a bit of oil. It does not have a o'ring or crush washer on it. How did these come stock? Was there a seal of some sort, or was the plug just supposed to seal against the housing? What are people running?

Locking for one locking hub.

Have not had to deal with spun bearings before, just guess I have been lucky all my life. Got a rig with spun outer wheel bearings (inner has some damage but seems ok). Looking for guidance on if the spindles are runnable or need to be replaced. They measure out at 1.625 in the unworn section...

Need outer gear, inner gear and spring for 66 early style. Will take complete lockout if that is what's available. (shop installed spring retainer plates backwards and wiped everything out).

Backlash at 010-012. Thoughts?

Getting ready to set up a new diff, looking to figure out the starting point for pinion depth. My old one was marked +1. Having a difficult time reading the number on this new USA Standard Gear set. What would you read this number as? 0?

Lighter Socket - $5 Full Set Lug Nuts - $5 SOLD Coil Yellow Top - $10 Valve Cover Breather FoMoCo - $15 SOLD Locking Gas Cap - $5 Choke Cable 66 Knob and retaining clip - $30 SOLD Antenna - $10 SOLD Alternator Wiring Harness (not 66) - $5 Plus shipping.

Can someone post some measurements for the engine badge location on the front fender? I need to drill some holes and make sure I get them in the correct spot. (PS - no side maker lights location for reference, so measurements from front and top/fender side crease would be best).

1 Set MasterCraft 2" Grab Handles Red New (2 in package) $20.00 OBO plus shipping.