Search results

My Apology Chuck I wish you and your new location the best of luck. May God prosper you abundently. I have checked the items you asked the mounts are good motor,tranny and body. I tried to pull the body with a com-a-long all directions and got very little movement toward the radiator to fan...

bulb It is in fact the brake warning light I have a 67. However I replaced it and the lens warped and fell out of the new one from the bulb being on too long. Reset the device located on the frame below the master cyl. The brake lines from the master cyl connect to it. The procedure should be...

my reply BC Chuck thanks for owning up to being the manufacturer of this radiator gaurd. But when someone purchases somthing from ANY manufacturer there is an implied warranty. That is it is expected to work as intended for a reasonable amount of time under a certain condition. It looks like...

Don't use a radiator gaurd Don't depend on the radiator gaurd to do anything but destroy your radiator if a strap failure occurs. THis happend to me and it ruined a brand new radiator caused by the tie strap connector failing causing the gaurd to bounce back and forth until the fan blade...

You really don't know how much integrity a company has until you have to put a damage claim in for hundreds of dollars of damage caused by a product that this company sells to Bronco Owners all over america. So the warning is this DON'T BUY FROM JEFF'S BRONCO GRAVEYARD!!! I recentley did a...

The J shift will allow you to dual shifters later if you want the option of several combo of dirive. i.e. front wheel only rear only and hi and low in each

THanks for the help I think Im good to go the old flexplate never caused a vibration on my old 351w block so I think it should be OK. I understand if it was wrong there would be one violent vibration at lower rpms.

edelbrock makes a bolt on fuel injection system $2600 with all the harnesses its complete kit not cheep!!

Does anybody know how to tell the difference between a 28oz flexplate and a 50oz. for a c4 302/351w

update Ford says it takes a 164 tooth 11.4" bolt pattern. i was thinking this was something unusuall for broncos (10.5" bolt pattern) can you go out and measure the bolt pattern its measured the long way across the wheel. Yes 351w will be put back in its the same flywheel as the 302 28oz unbalance

I have a 67 Bronco w/ 73 C4 trans and 351w engine need to replace flywheel however Ford says they never made a flywheel with 164 teeth & 10.5" bolt pattern. Now Im thinking I might have the wrong flywheel maybe a 50oz instead of the proper 28oz. balanced flywheel. I want to put a new crate...