Search results

I took my 73 to the shop the other week to get them to finish up my build. I hated to do this but it had to happen. The truck has new everything but is the original motor from before the build started a few years ago. I have switched to a single wire HEI distributor. I have the timing set at...

Went to put the front drive shaft in today. It will not come close to working with the cross member that came with the kit. Bought it used but I think the kit is from BC broncos. I am running a 5.5 cage lift which is a major part of why it will not reach the front axle. Wanted to know what...

Hey Guys, I am looking for some advice on car Insurance for the old LUBER. I have way to much invested in it to have it on a liability only policy. I wanted to know who y'all use. I have tried hagertys and I put down to many miles a year for them to even take a look at me. It was a typo on...

I was reading on a post, and now can't find it, about an adj rear block. It has the ability to stay stock, 1" or 1.5" front or back. I am looking for a link to this item and am wondering if anyone has used it. Thanks in advance! BP

Hey Guys, Have a quick question for all the zf people floating around. I am working with a brake master that is in on an angle and was wondering what everyone has done to fit in the clutch M.C. in that case. Thanks for the help! BPJr.

I have search and searched to find where and how the balls are spose to be lined up. Are they spose to go inbetween the tube and if so how are you spose to get them to stay that way. I have it all back together and after looking at where they were located, I did not feel that it looked right...

I hate to sell it but my other love said I have to make room! I have owned this truck for 12 years and most of what has been done to the truck, I have done. The 302 has a fresh bottom in it w/a 2bl carb and 289 hi/po heads. The trans and transfer case have both been gone through. It has a new...

Hey guys and gals, I am new to this forum. I have owned my 73 for about 8 years and now it is time to start a total rebuild on it. I am going to start first on the body and work in. The first thing that I was looking at was the way the lines are on this truck and I can see where somone...