tk1218
Bronco Guru
Ok, on my 66, the fuseable linkage was fried and I replaced it. I believe it was on wire 37 (it is the wire that does not go to the cluster directly for the ampmeter). I replaced the linkage with a 40 amp fuse and it was working fine.
Last night I was swapping out the cluster with the battery disconnected and turned it all back on when done and the fuse blow. I replaced the fuse and everything worked briefly, but now, no power to anything. The fuse has not blown again.
Looking at the fuse block, it appears there is some custom wiring involved by PO. I will try and get some pics of that tomorrow.
I assume I need to trace the power to the point where it is not working.
Last night I was swapping out the cluster with the battery disconnected and turned it all back on when done and the fuse blow. I replaced the fuse and everything worked briefly, but now, no power to anything. The fuse has not blown again.
Looking at the fuse block, it appears there is some custom wiring involved by PO. I will try and get some pics of that tomorrow.
I assume I need to trace the power to the point where it is not working.