• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Lowering Bronco - taking out BL

Justafordguy

Bronco Guru
Joined
Sep 26, 2009
Messages
6,255
Looks like going tie rod over on the pitman will get you a lot closer to parallel with the trac bar. I bet that pitman was drilled when the heim steering was installed. You may just be able to unbolt and bolt it on the top. Some of the heim steering doesn't use a tapered hole.
 
OP
OP
MPG_Bronco

MPG_Bronco

Full Member
Joined
Apr 16, 2012
Messages
346
Loc.
Chandler
thinking about taking the 2 inch body lift out. Hoping to tuck the 33inch tires some more into the wheel wells.


I have thought of the following to check to see if I can.

Bumpers (both are aftermarket)
gas tank (aftermarket, I think's its a 23 gal)
radiator
steering wheel shaft
column shift c4
brake lines

If the bumpers don't get in the way of dropping the body down, I will go ahead, otherwise I'll leave it.

the gas tank: I can get longer bolts, get 4 blocks and lower it about 1.5-1.75 inches as I have about 1.5 inches of room between tank and rear floor.

radiator: hoses mostly I believe, nothing too crazy I hope, will have to re-position the fan shroud.

steering wheel: loosesn the mounting bolts before I start dropping, the U-joint should be able to compensate for the decreased angle.

column shift c4: do I need stock ones? or can I get away with adjusting them, would they have enough to adjust?

brake lines: not being stretched, so they should be fine being little long to the MC.

anything else you can think of?
 
Top