OP
OP
rockingm82
Full Member
I feel like I am forever delayed by my obsessive compulsive need to replace all fasteners in this rebuild.
Received my bell housing from Driven. After clearancing the bell housing for the NV3550 kit I cleaned it, prepped it, and painted with POR 15. Filed the NV3550 for bolt clearance and attached the Advance Adapters Plate. Installed the dowel plate, pilot bushing, and flywheel. Torqued the flywheel to 80 ft/lbs. The photo doesn't show all the bolts in the flywheel. Don't worry, they're all installed;D
Now waiting on pressure plate bolts to show up.
Received my bell housing from Driven. After clearancing the bell housing for the NV3550 kit I cleaned it, prepped it, and painted with POR 15. Filed the NV3550 for bolt clearance and attached the Advance Adapters Plate. Installed the dowel plate, pilot bushing, and flywheel. Torqued the flywheel to 80 ft/lbs. The photo doesn't show all the bolts in the flywheel. Don't worry, they're all installed;D
Now waiting on pressure plate bolts to show up.
