• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Learn me up-NP435 behind a 6cyl

bigjhoov

nobody
Joined
Apr 10, 2005
Messages
3,583
I have a NP435 and adapter, now tell me what to expect when installing it. I've heard you have to move the crossmember back, is this true? Where's Pappit?
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
Yes it can go in. Transfer case will have to move back, drive shaft lengths will need to be adjusted. Use any of the adaptors that work with the V8. Use the stock I6 bellhousing. Follow the normal items that you would with a V8. Crossmember and transfer case shifter will need relocating.

Basicly it is just like the normal V8 except the transmission you are replacing (actually the tailhousing) is shorter, So you will have a V8 length transmission in there and since you can't shove the engine forward to the V8 bellhousing location, the transmission will have to be in the I6 location, further back then the standard V8. Thus everything will move back a little.
 

Pa PITT

Contributor
Bronco Guru
Joined
Jul 15, 2005
Messages
11,300
Loc.
Stephenville TEXAS
OK here I am ...ya this one worked great .He had to get one adaptor on the trans but he did have to move the cross member back about 2 inches he just made 2 pieces to bolt in the old holes on the frame and then drilled 2 holes each and used his old crossmember ...as for the drive shafts everyone kept telling us we'd have to buy new shafts front and rear ...about 500.00 worth ..but we got to looking at them ..we just swaped the front yoke to the rear and the rear yoke to the front shaft worked great ...it's been running about 3 to 5 years or so and has made 2 big 4wheeling hunting trips to NewMexico ...
The box to go over the shifter ..to cover the hole well we took a oil box ...
ya cardboard ...ducktaped it together ..got the correct shape then put about 4 coats of fiberglass on it inside and outside then sprayed it with bed liner and undercoating ...worked great ..His shifter didnt even have to be
bent ..ONE more thing put a new clutch in it and turn your flywheel ...
He sure liked this swap until he put power steering on it ...now p/s is the best....
 
OP
OP
bigjhoov

bigjhoov

nobody
Joined
Apr 10, 2005
Messages
3,583
Almost done.

435_020.jpg


435_019.jpg
 

OX1

Bronco Guru
Joined
Aug 26, 2003
Messages
3,472
brianlowry said:
Wow. that's a lot of cutting. I'm getting ready to do mine in a few weeks. Good luck!

No choice without a body lift, trans has to slide back alot before it can drop down. I cut just a bit less than that.
 
OP
OP
bigjhoov

bigjhoov

nobody
Joined
Apr 10, 2005
Messages
3,583
Still getting a few things buttoned up. Works great! I just swapped the drive shaft yokes from front to rear, and rear to front.


435_018.jpg



435_021.jpg



435_022.jpg



435_024.jpg



435_025.jpg
 
Top