I am going to add side panels to one of my broncos for speaker installation-
Does anyone make the brackets that weld to the wheel well? or are they just 16-18 ga angle iron?
Does anyone have the location for these? My thought was to plumb down from the bed side and put the back of the angle facing toward the cab, but I think I have seen stock trucks with the back facing the inner fender and the leg sticking out from underneath the panel. Which is right?
Thanks in advance.
Does anyone make the brackets that weld to the wheel well? or are they just 16-18 ga angle iron?
Does anyone have the location for these? My thought was to plumb down from the bed side and put the back of the angle facing toward the cab, but I think I have seen stock trucks with the back facing the inner fender and the leg sticking out from underneath the panel. Which is right?
Thanks in advance.