- Joined
- Nov 21, 2011
- Messages
- 24
Finally getting back to my build but plan to go a slightly different direction. In the pictures are shown all the fuel injection parts I have accumulated for the past few years. Upper and lower manifolds are from a 98 Explorer engine (which I still plan to use) and the harness is setup to use as many of those sensors as possible.
I am pretty sure everything is here to get going. Since it has been a while, and also since I don't really want to add the costs of these parts up, I am not quite sure what to ask for a price.
Included parts list:
RJM harness
Mustang manual trans computer
Upper and lower from 1998 explorer
Distributor from 1993 mustang with replacement TFI module
Fuel rail and injectors
New heater pipe
Throttle body
New MAF
Barimetric pressure sensor
Inertia sensor
EGR block off
New cap and rotor
New coil
New oxygen sensors
I am pretty sure everything is here to get going. Since it has been a while, and also since I don't really want to add the costs of these parts up, I am not quite sure what to ask for a price.
Included parts list:
RJM harness
Mustang manual trans computer
Upper and lower from 1998 explorer
Distributor from 1993 mustang with replacement TFI module
Fuel rail and injectors
New heater pipe
Throttle body
New MAF
Barimetric pressure sensor
Inertia sensor
EGR block off
New cap and rotor
New coil
New oxygen sensors