Sanderson shorty headers

[SSDDBRONCO]

Anyone running the Sanderson shorty headers with the v-band or 3 bolt collector?

I'm looking at the v-band setup but was wondering if anyone has one installed with a 351W?

If so any clearance issues?

Thanks

 

[SSDDBRONCO]

These are the ones I'm looking at

 

[Madgyver]

I got these for the Cleveland canted valve type heads..
we are planning for a motor swap after New Year 2022.

 

[EPB72]

Anyone running the Sanderson shorty headers with the v-band or 3 bolt collector?

I'm looking at the v-band setup but was wondering if anyone has one installed with a 351W?

If so any clearance issues?

Thanks

Yes the 1 5/8 tube version 3 bolt flange..with iron heads ,,only slight clearence issue is on passenger side wheel tub back corner were collector is you can tweak sheet metal a little or just cut that little corner area out..

 

[Bitch'nBronco]

Yes the 1 5/8 tube version 3 bolt flange..with iron heads ,,only slight clearence issue is on passenger side wheel tub back corner were collector is you can tweak sheet metal a little or just cut that little corner area out..

I have the same setup, with a 1" bodylift I had enough room but if it wasn't there I'd definitely would have had to move some of the wheel tub around like you mentioned

 

[SSDDBRONCO]

Thanks all! I got in touch with the owner and he said with a 2 inch body lift it's really close to the passenger inner wheel fender wells, so like y'all mentioned just a little massaging or cutting for me since i run a 1" body lift