Community
Message Forum
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Tjboriack
- Messages
- 27
Latest activity Postings Images Garage items About
-
-
Tjboriack replied to the thread Bronco Cooling System.see the image - the air flow pull can hold cardboard on the front of the a/c/ condenser at an idle -
-
Tjboriack replied to the thread Bronco Cooling System.I am curious as to the thoughts of how much heat the transmission may be adding if the lines are flipped. looks like I have...
-
Tjboriack replied to the thread Bronco Cooling System.base timing was at ~20 degrees - moved it back to about ~10
-
-
Tjboriack replied to the thread Bronco Cooling System.Alright folks - I finally had some time to get back to the Bronco. I have made the following changes - moved from a 5-15/16" water...
-
you could always try putting a hose temporarily between the inlet of the rad trans cooler and the exit so that the fluid doesn't go in...
-
Tjboriack replied to the thread Bronco Cooling System.just ordered it, it's an easy add-on that I can do when I tear into it next and plenty of people on a variety of threads in this forum...
-
Tjboriack replied to the thread Bronco Cooling System.have tried the A/C - it is fine going down the road - does at a few degrees, but not horrible. Sitting in traffic it definitely runs...
-
Tjboriack replied to the thread Bronco Cooling System.pretty certain the rotation is correct on the water pump - been a little while since I replaced it but was a big watchlout for me then...
-
Tjboriack replied to the thread Bronco Cooling System.Thanks for the notes Gauge reads correctly - have been tracking with a laser thermometer for awhile. Plan on going to a 180 degree...
-
Tjboriack replied to the thread Bronco Cooling System.thank you
-
Tjboriack replied to the thread Bronco Cooling System.here are a couple of pictures of the engine compartment prior to cutting the shroud. the top of the fan was completely covered.
-
-
Tjboriack replied to the thread Bronco Cooling System.any one have a stock factory engine that can measure the water pump pulley diameter and the crankshaft pulley for me?
-
Tjboriack replied to the thread Bronco Cooling System.Yes I have an A/C and the condenser sits in front. It has been a concern of mine, but everyone I talk to doesn't think it is an issue...
-
Tjboriack replied to the thread Bronco Cooling System.I have about 1.25" from the fan blade to the radiator up top and about 1" at the bottom. from the leading edge of the fan to the back...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
